withgasil.blogg.se - 4 gas monitor in breathing zone

4 gas monitor in breathing zone full#
4 gas monitor in breathing zone pro#
4 gas monitor in breathing zone plus#

RP-3R Clip-on sampling pump with 4” rubber nipple, 10’ hose and probe (up to 40’ hose available) Logs user ID, station ID, Calibration & Bump Test history, Alarm Events & Alarm Interval TrendsĪlligator clip, protective rubber boot, charger, and calibration adapter 105 g) with rubber boothĮxplosion proof, dust and water resistant to IP-66/68 (2m,1h) approval. 61 W x 67 H x 27 D mm), 3.70 ounces (approx. 58 W x 65 H x 26 D mm), 3.52 ounces (approx.

4 gas monitor in breathing zone full#

25 hours after a 3 hour full chargeĢ.2” W x 2.55” H x 1.02” D (Approx. 40☌ ~ +60☌, 0 to 95% RH, non-condensing (temporary environment, 15 minutes) 20☌ ~ +50☌, 10 to 90% RH, non-condensing (continuous environment) Trouble alarm: Flashing LEDs, intermittent buzzer (95 db 30 cm), display of error message Gas Alarm: Flashing LEDs, continuous buzzer (100 db 30 cm), flashing gas value, vibration Trouble alarm: Sensor disconnection, low battery, circuit error, calibration range error Gas Alarm: 3 Increasing alarms, STEL, TWA, overscale alarm.

4 gas monitor in breathing zone plus#

Gas Detectedĭiffusion sampling standard (hand aspirator or clip-on motorized pump optional)ĭigital LCD displays with 7 segment plus 14 segment plus icon The 3 LED lights will continue to flash once every 30 seconds until the non-compliance condition has been resolved. The instrument flashes it’s 3 LED lights every 30 seconds in the following conditions if the instrument has not been bump tested, or if calibration is due, or if there was a gas alarm event. Safety supervisors will appreciate the non-compliance indicator. H2S and CO are now available in a combo micro sensor. The new O2 sensor is electro chemical with a 3 to 5 year life span. If one filament gets poisoned the second filament takes over. The LEL sensor has a unique design with two active filaments in one sensor to increase it’s resistance to silicone poisoning. The GX-3R represents the latest evolution of gas detection technology utilizing a new generation of micro sensors. It simultaneously monitors and displays LEL combustibles, O2, CO (Hydrogen compensated CO also available), and H2S. The GX-3R is the worlds smallest 4 gas monitor weighing only 99.79 grams and can comfortably be clipped within a worker’s breathing zone. Now there is a 4 gas monitor smaller than many single gas monitors. Traditionally this means only a single gas monitor would be small enough for a worker to practically wear a gas monitor ‘In the breathing zone’. Air sampling filters may be attached to the collar or lapel.

OSHA defines the breathing zone as a ten inch radius around the worker’s nose and mouth, and requires that worker exposure monitoring air samples be collected in the breathing zone.

Configure it to send alarm notifications and location to your desired contacts in case of emergency.

Connect to the RK Link app to view direct instrument readings.

Two interchangeable sensor slots providing flexible configurations.

4 gas monitor in breathing zone pro#

Weighing only 129.84 grams, it fits in the palm of your hand! In addition to the four confined space gases (CO, H2S, LEL, O2) the GX-3R Pro has a 5th channel for toxic and infrared sensors that can monitor:Īdditionally, the GX-3R Pro comes equipped with:

The sensors are field replaceable: Easy to change in less than 60 seconds.

Available with a hydrogen compensated CO sensor (as LEL/O2/CO).

H2S and CO are now monitored by one combination micro-sensor.

The new O2 sensor has a 3 to 5 year life span.

The new LEL sensor has two active filaments to increase its resistance to silicone poisoning.

Both the GX-3R and the GX-3R Pro utilize a new generation of micro sensors: Weighing only 99.79 grams, it clips comfortably within a worker’s breathing zone.